The border style and material used to reflect the formality of the lagoon and the materials used in the garden elsewhere. A formal pond looks better with a clean right pavement edge, while the casual may be paved with stones of irregular shape or small unit of pavement, you can follow the gentle curves of the lagoon. Around the edge of a wildlife pond, a pendant of the pebble beach would be wise to visit the wildlife can enjoy a swim and a drink. Then I want to show you how to install a preformed rigid liner.
The transfer of land formed by the insertion of rods around the edge of the device. Use a garden hose, rope or sand to mark the outline on the floor. Remove the unit and poles and dig the hole to about the depth required, depending on the profile of the shelves as accurately as possible. Use a spirit level and straight edge board, placed across the rim to make sure it is level. Measure down to verify that it is the required depth. Remove large stones. Put the pond in the hole, then add or remove soil to ensure adequate and appropriate level. Check with a spirit level that the pond is level.
Remove the tank and line the hole with wet sand if the soil is rocky. With the tank in place and controlled levels again, fill with sand or fine soil, being careful not to push the level of the pond. Fill with fresh water and the embankment is also necessary that the water level rises, often checking level to ensure that the coating did not move. Let stand for a few days before planting with plants. Board or brick pavers creates a very formal, but the pond became more interesting to use the excavated soil to build a raised bed behind her.
In rocky terrain, you may need to align the hole with additional loft insulation or special sublayer pond liner. Cut the sub-coating layer so that it fits in the hole. Facilitate position without unduly stretch lining. Choose a hot day, and it will make it more flexible. Weigh the edges with stones, then fill the tank slowly. Ease lining position so that it follows the contours of the pond is full. Once the pond is full, cut the excess fabric to allow an overlap of at least 6 inches around the edge. Cover with paving or overlay coating edge.
The transfer of land formed by the insertion of rods around the edge of the device. Use a garden hose, rope or sand to mark the outline on the floor. Remove the unit and poles and dig the hole to about the depth required, depending on the profile of the shelves as accurately as possible. Use a spirit level and straight edge board, placed across the rim to make sure it is level. Measure down to verify that it is the required depth. Remove large stones. Put the pond in the hole, then add or remove soil to ensure adequate and appropriate level. Check with a spirit level that the pond is level.
Remove the tank and line the hole with wet sand if the soil is rocky. With the tank in place and controlled levels again, fill with sand or fine soil, being careful not to push the level of the pond. Fill with fresh water and the embankment is also necessary that the water level rises, often checking level to ensure that the coating did not move. Let stand for a few days before planting with plants. Board or brick pavers creates a very formal, but the pond became more interesting to use the excavated soil to build a raised bed behind her.
In rocky terrain, you may need to align the hole with additional loft insulation or special sublayer pond liner. Cut the sub-coating layer so that it fits in the hole. Facilitate position without unduly stretch lining. Choose a hot day, and it will make it more flexible. Weigh the edges with stones, then fill the tank slowly. Ease lining position so that it follows the contours of the pond is full. Once the pond is full, cut the excess fabric to allow an overlap of at least 6 inches around the edge. Cover with paving or overlay coating edge.